EMT Practice Test

1. Question Content...

---

Question1: Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

Question2: Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.

What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?

Question3: Which statement is correct about SD-WAN and ADVPN?

Question4: Refer to the exhibits.


Exhibit A shows the SD-WAN rule status and the learned BGP routes with community 65000:10.
Exhibit B shows the SD-WAN rule configuration, the BGP neighbor configuration, and the route map configuration.
The administrator wants to steer corporate traffic using routes tags in the SD-WAN rule ID 1.
However, the administrator observes that the corporate traffic does not match the SD-WAN rule ID 1.
Based on the exhibits, which configuration change is required to fix issue?

Question5: Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured packet loss will make T_INET_1_0 the new preferred member?

Question6: Which two statements about the SD-WAN zone configuration are true? (Choose two.)

Question7: Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)

Question8: Refer to the exhibit, which shows an SD-WAN zone configuration on the FortiGate GUI.

Based on the exhibit, which statement is true?

Question9: Refer to the exhibits.
Exhibit A

Exhibit B -

Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.
The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule.
Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?

Question10: Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )

Question11: Refer to the exhibit.

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?

Question12: Refer to the exhibit.

An administrator used the SD-WAN overlay template to prepare an IPsec configuration for a hub-and-spoke SD-WAN topology. The exhibit shows the installation preview for one FortiGate device. In the exhibit, which statement best describes the configuration applied to the FortiGate device?

Question13: Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows the source NAT (SNAT) global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two actions does FortiGate perform on existing sessions established over port2, if the administrator increases the static route priority on port2 to 20? (Choose two.)

Question14: Exhibit.

The exhibit shows the output of the command diagnose sys sdwan health-check status collected on a FortiGate device. Which two statements are correct about the health check status on this FortiGate device? (Choose two.)

Question15: Which two statements about SLA targets and SD-WAN rules are true? (Choose two.)

Question16: Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

Question17: What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

Question18: Which two interfaces are considered overlay links? (Choose two.)

Question19: Refer to the exhibit.

Based on the exhibit, which action does FortiGate take?

Question20: Refer to the exhibit.

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)

Question21: Refer to the exhibits.


An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in exhibit A.
After generating GoToMeeting test traffic, the administrator examined the respective traffic log on FortiAnalyzer, which is shown in exhibit B.
The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.
Which two reasons explain why the traffic matched the implicit SD-WAN rule? (Choose two.)

Question22: Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

Question23: Refer to the exhibits.

Exhibit A shows two IPsec templates to define Branch_IPsec_1 and Branch_IPsec_2. Each template defines a VPN tunnel.
Exhibit B shows the error message that FortiManager displayed when the administrator tried to assign the second template to the FortiGate device.
Which statement best explain the cause for this issue?

Question24: Which SD-WAN setting enables FortiGate to delay the recovery of ADVPN shortcuts?

Question25: Refer to the exhibit.

Which conclusion about the packet debug flow output is correct?

Question26: Refer to the exhibit.

Which two SD-WAN template member settings support the use of FortiManager meta fields? (Choose two.)

Question27: Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

Question28: Which are three key routing principles in SD-WAN? (Choose three.)

Question29: What three characteristics apply to provisioning templates available on FortiManager? (Choose three.)

Question30: Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)

Question31: Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

Question32: Refer to the exhibit.

Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)

Question33: What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)

Question34: Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Question35: Which two statements are true about using SD-WAN to steer local-out traffic? (Choose two.)

Question36: The SD-WAN overlay template helps to prepare SD-WAN deployments. To complete the tasks performed by the SD-WAN overlay template, the administrator must perform some post-run tasks. What are three mandatory post-run tasks that must be performed? (Choose three.)

Question37: Exhibit.

Which conclusion about the packet debug flow output is correct?

Question38: Refer to the exhibit.

An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)

Question39: Refer to the exhibit.

The exhibit shows the details of a session and the index numbers of some relevant interfaces on a FortiGate appliance that supports hardware offloading. Based on the information shown in the exhibits, which two statements about the session are true? (Choose two.)